Is your up and over garage door slipping or drooping when you open it or is it just not staying open at all.
Up and over garage door won t stay open.
If your garage door won t open when you re attempting to use the keypad it s often as simple as replacing the battery.
Enter the garage by the side door then you can open the main door using the internal handle.
Most likely the door is not plumb meaning that the hinges do not line up as they should.
The door frame and door are tilted and the unbalanced weight of the door causes the door to close on its own.
Having a door which won t stay open or which droops when at the height of its lift can be troublesome.
Why won t the door stay open on its own.
There can be a few reasons as to why your garage door won t stay closed and by doing some snooping and checking a few parts of the garage door system you ll be able to see what s really going on.
Don t worry this is perfectly repairable.
The door won t stay open.
The door in question may not be plumb because its hinges and frame were improperly installed.
The main reason for this is that the springs aren t holding as they should you will need to have your springs adjusted to give your garage the ability to hold the weight of the door.
If that doesn t work follow the reprogramming instructions located on the door to your keypad or in the user manual.
If you can t find any obvious obstructions or have done what you can but the door still won t open properly give us a call and one of our friendly team will be happy to take a look.
These steps are usually quick simple and usually get to the bottom of your basic keypad issues.
Hold the garage door and remove the vise grips from the track after the spring tension has been adjusted.
You can continue to use the door this way until you have the lock and or handle.
In either of the above cases you will probably be able to open the door from the inside because the mechanism incorporates an internal handle that operates independently of the exterior handle.
If the latter then it has probably become detached from the release mechanism so the door will not unlatch from the outside.
Ideally the door should slowly float up from this point.
When investigating the issue look for items inside the garage that could be obstructing the door.
Adjusting the limit travel setting.
One of the more difficult problems for do it yourselfers to diagnose is a worn cable pulley on an extension spring door.
When the door is lowered the spring winds up tightly creating a pulling force that helps lift the door up when you next open it.
Slowly close your door about halfway and release it.
This page should help you troubleshoot your garage door problems.
Over time torsion springs wear out and break making the door.