If the joint is taller than wide place the holes vertically.
Tying concrete walls together.
This tie is made by going about 1 1 2 times around the vertical bar then diagonally around the intersection twisting the two ends together until the connection is tight but without breaking the tie wire then cutting off the excess.
Pull the tip of the gun out of the hole as it fills.
Insert the tip of the epoxy gun into the hole as far as you can.
Make these holes 12 inches on center horizontally or vertically depending upon the predominant orientation of the joint.
Snap tie concrete forms are a simple and easy system for foundation walls.
Drill 5 8 inch diameter holes six inches deep into the old concrete.
Use rebar about 1 3 in 0 85 cm in diameter to reinforce the concrete.
The wall tie is used on light vertical mats of steel.
Place a layer of steel rebar of the way up the hole.
If the joint is wider than it is tall place the holes horizontally.
Then pack the cores with mortar around the angle and seal the joint between the new blocks and the old wall with a good elastomeric caulk.
This will provide lateral support to the wall but will allow some minor vertical movement without cracking.
Thank you for all your support https www paypal me mountainhomestead essential.
Fill the hole with epoxy slowly.
This tie is used mostly on floor slabs.
Lay the rebar in a grid with the bars spaced about 12 in 30 cm apart.