Lightning eliminators has been protecting communication towers around the world for over 43 years and has witnessed first hand the advancements and changes that have occurred due to innovation.
Tower lightning rod installation.
The top of the light terminal shall be installed at least 2 meters over the area that it protects including antennas refrigerating towers roofs and tanks.
With this in mind lec has created a solution which makes it easy to implement a complete lightning protection system specifically designed with a tower s safety and operations in mind.
For towers located closer than 50 from the house a strap should be also run from the tower ground system to the single point ground point at the service entrance of the home.
The minimum section must be 50 mm.
The tip of the lightning rod ese should be located at least 2 mt above any element that is within the protected area including antennas cooling towers roofs tanks etc.
Contact lightning master corporation at 800 749 6800 and set up an appointment today.
Nature the down conductors may be tapes tape braid stranded wire or solid round.
This type of arrangement permits lightning strike charges to flow not only through the mast or structure but through the attached sensitive equipment as well.
Material observations dimensions electrolytic copper.
As the installation of lightning rods is a protection system it is very important that it is performed by technically qualified personnel and under the current regulations.
Contact lightning master corporation for communication tower lightning protection.
Use wide copper strap with the same ground rod spacing used in the tower.